LSR — Liquid Silicone Rubber
Liquid silicone rubber is injection molded for precise, thin-wall and complex parts — the route when consistency and fine detail matter more than anything else.
Typical Properties
| Hardness (typical) | Typically Shore A 10 to 80 (commonly 20 to 70) |
|---|---|
| Temperature range (typical) | Typically −50°C to about 200°C |
| Key strengths | Precise thin walls and complex shapes; very consistent parts from automated injection molding; clean, flash-free finish; good heat and weather resistance. |
| Limitations to note | Tooling cost is higher than compression molding, so it fits repeat volumes rather than one-off parts — quantities decide whether it pays. |
Values shown are typical ranges for the material family. Actual values depend on the compound and are confirmed from the material data sheet for your order.
Typical Applications
- Seals and diaphragms — precise sealing in small assemblies
- Gaskets — thin, even gaskets for enclosures and devices
- Precision molded parts — small, detailed components
- Overmolded parts — silicone bonded onto a substrate, confirmed per design
What to Specify in Your RFQ
- Hardness — Shore A value your application needs
- Wall thickness and tolerances — from the drawing
- Operating temperature — lowest and highest the part will see
- Quantity — LSR fits repeat volumes; tell us the batch size
- Overmolding or inserts — if the part bonds to metal or plastic
Send the drawing with the specification — hardness, dimensions, operating temperature and media contact decide whether this material fits, and we confirm it from the data sheet before molding.
Compare Materials
Silicone (Solid / HTV)
Solid silicone rubber (HTV) for gaskets, seals, grommets, boots and covers. Typically −60°C to about 230°C, with excellent weathering, ozone and UV resistance.
EPDM
EPDM rubber for weather seals, water-system seals and HVAC gaskets. Typically −50°C to about 150°C, with excellent weathering, ozone and steam resistance.
NBR (Nitrile)
Nitrile rubber for oil seals, O-rings and fuel-system parts. Typically −40°C to about 120°C, with good resistance to oils and fuels.
FKM (Fluoroelastomer)
Fluoroelastomer for fuel, chemical and high-temperature sealing. Typically −20°C to about 200°C, with strong resistance to fuels, oils, chemicals and heat.