Silicone (Solid / HTV)
Solid silicone rubber (HTV) is the general-purpose choice for sealing and protection where temperature swings, weather and flexibility matter.
Typical Properties
| Hardness (typical) | Typically Shore A 20 to 80 |
|---|---|
| Temperature range (typical) | Typically −60°C to about 230°C |
| Key strengths | Excellent resistance to weathering, ozone and UV; stays flexible at low temperatures; good electrical insulation; soft touch and easy compression sealing. |
| Limitations to note | Not the first choice for continuous oil or fuel contact — tell us the media and we will say so plainly if another material fits better. |
Values shown are typical ranges for the material family. Actual values depend on the compound and are confirmed from the material data sheet for your order.
Typical Applications
- Seals and gaskets — equipment housings, enclosures and lids
- Grommets — cable and panel pass-throughs
- Boots and covers — dust and water protection for moving parts
- Cushion pads — vibration and shock absorption
- Food-contact parts — grades for food contact are available on request; documentation is confirmed per order
What to Specify in Your RFQ
- Hardness — Shore A value your application needs
- Dimensions and tolerances — from the drawing
- Operating temperature — lowest and highest the part will see
- Media contact — water, air, steam, oil or chemicals
- Quantity — trial batch or batch volume
- Color — if the part must match a color
Send the drawing with the specification — hardness, dimensions, operating temperature and media contact decide whether this material fits, and we confirm it from the data sheet before molding.
Compare Materials
LSR — Liquid Silicone Rubber
Liquid silicone rubber, injection molded for precise, thin-wall and complex parts in consistent batches.
EPDM
EPDM rubber for weather seals, water-system seals and HVAC gaskets. Typically −50°C to about 150°C, with excellent weathering, ozone and steam resistance.
NBR (Nitrile)
Nitrile rubber for oil seals, O-rings and fuel-system parts. Typically −40°C to about 120°C, with good resistance to oils and fuels.
FKM (Fluoroelastomer)
Fluoroelastomer for fuel, chemical and high-temperature sealing. Typically −20°C to about 200°C, with strong resistance to fuels, oils, chemicals and heat.